Just set the box on its side. Just slide the printer out of the box by
pulling on the plastic. It should come out fairly easy at this point.
Once the printer is out you can set the box aside.Now we can remove the
printer from the plastic. I find it’s easiest if you just set the
printer on it’s back and then slide the plastic off. Then just rotate
it back. Now we can start to remove any tape or other packaging
materials that are on or inside the printer. Just peel back the
tape.It’s designed to come off fairly easily and not leave any residue
on the printer.
 |
| HP-Officejet-Pro-8600-Plus-e-All-in-One-About-6-300x209 |
HP Officejet Pro 8600 Plus e-All-in-OneTake the tape off the scanner lid and then lift up the lid to remove the protective film. Take the tape off the input and output trays. For this piece of tape, you will have to slide out the input tray and then remove the styrafoamand cardboard that’s inside the tray. Then just slide the tray back into place.All over the high gloss parts on your printer are covered in a protective film that you can remove. So any of the parts that are reflective or shiny, you can remove the film that is covering it, including your control panel. Once all the tape and protective film is removed we can install the duplexer. Go to the back of your printer.
 |
| HP-Officejet-Pro-8600-Plus-e-All-in-One-About-7-300x199 |
HP Officejet Pro 8600 Plus e-All-in-OneHolding the duplexer in one hand, slide it directly into the back until you hear it snap into place. Return to the front of the printer.Now we can remove the tape and other packing materials from the 2nd tray. Remove the fewpieces from the front. Some of the tape goes underneath so you’ll have to lift it up.And now just like the other tray, slide this one out and remove the tape, styrafoam, and cardboard. Once it is all out you can slide the tray back into place. Now we want to center up the 2nd tray and then grab the printer and set it on top. There are little pins and slots that are designed so the tray and printer line up perfectly.
 |
| HP-Officejet-Pro-8600-Plus-e-All-in-One-About-5-300x211 |
HP Officejet Pro 8600 Plus e-All-in-OneOh, almost forgot, you need to check inside the ink access door for any packing material as well. Then you can close the door. So now that everything is unpacked and ready, we can start setting up the hardware. The first thing we are going to do is connect the power cord. Start by removing the twisttie that’s on the power cord. Now we can plug the power cord into the back of the printer.Let me turn the HP Officejet Pro 8600 printer around so you can see what I’m doing. So go ahead and plug in the cable into the printer making sure its firmly in place. Then we are going to take the power cord and plug it into a power source.
 |
| HP-Officejet-Pro-8600-Plus-e-All-in-One-About-8-300x300 |
